The
Tyent
Citric Acid Ionizer Cleaning Cartridge is a MUST HAVE in areas with
hard water! In fact even if your water is not particularly hard it
is recommended that you use the cleaning cartridge at least once
every year. Why? Have you ever used a pot to boil water over
and over without washing it? What occurs? A white film begins to
build up. Well, this same water is running through your machine and
the electrolysis plates your machine works by attracting the calcium
and magnesium in your water to itself so it can be ionized. This
process will inevitably lead to a build up of calcium on the
electrolysis plates just like what you see in that pot. What does
this do? This scale build up forms a barrier between the water and
the electrolysis plate thereby reducing the effect of the
ionization. As this scale accumulates on plates your machine will
not be able to make the same quality alkaline water as when you just
bought it. If this continues and your Tyent MMP Water ionizer is not
cleaned it will have trouble making alkaline water and even worse
the calcium build up could get hardened over time making it even
harder for the cleaning cartridge to work.
Using
the Tyent Cleaning Cartridge will work to prevent problems like this
and help to keep your Tyent water ionizer running like new,
producing high alkaline and potent anti-oxidant water (with high ORP
values).
The
Citric Acid Ionizer Cleaning Cartridge expires after ONE use! Please
make sure to follow the step-by-step directions below to ensure
proper usage and prevent any damage to your ionizer:
Directions For Use:
1) Turn off your ionizer and shut off the water supply going to the
unit
2) Locate the filter housing of your ionizer and remove the 2nd
Filter by rotating it clockwise (the filter to the right when
looking at the back of the unit)
3) Attach the Citric Acid Ionizer Cleaning Cartridge by rotating the
cartridge counter-clockwise - do NOT over tighten
4) Turn both the power of the ionizer back on as well as the water
supply
5) Run water through the ionizer using the H20 CLEAN mode. DO NOT
use any other mode when going through this cleaning process!
6) Allow H20 Clean water to cycle for 15 minutes. In the case of
automatic shut-off (which commonly occurs every 5 minutes on some
models), simply restart the H20 Clean mode until a full 15 minutes
of water flows through the unit.
7) When finished, follow steps 1-4, replacing the Citric Acid
Ionizer Cleaning Cartridge with the original filter.